Skip to main content

Test Run and Clearing Stuck Reactions

Ways to trigger manually​

GoalFeature to use
Test including amount and message conditionsPut data into the MARS Event Input node and run it
Run a specific rule right nowTest Run above the rule in the Hub
Call a reaction from another blueprintMARS Manual Trigger node
  • Test Run skips conditions but follows the rule's Draw / Run All mode and Custom Parameter. The rule can be disabled.
  • MARS Manual Trigger picks a reaction (not a rule) and runs it with Custom Parameter 0. You can supply Nickname, Amount, and Message directly.
  • Regardless of method, execution policy and queue apply the same way. If nothing happens immediately, check the queued count in the Hub.

When the running count won't go to zero​

  1. Confirm the flow actually reaches MARS Complete.
  2. Check Recent Errors on the Complete node and Recent Notifications in Hub's MARS Execution Status.
  3. Under Troubleshooting at the bottom of the Hub, select the Stuck Reaction and click Force-Complete Selected Reaction.
  4. To also discard requests that haven't started yet, click Clear Queue.

Force-complete only releases MARS's "Running" status. Motions, props, and cameras already playing are not reverted — clean those up separately. Clear Queue also does not stop a currently running reaction.